Bing
Ajax  Loading... Please wait...

Filter Changing Procedure

Our Newsletter

Filter Changing Procedure

Machine Coolant Filtration Units

Filter Change Procedure
For CP 2002 (incl. Wall Mount) & CP 2020

 

Below are step by step procedure for changing the filter on our CP 2020 and CP 2002 Machine Coolant Filter Units.  For more information on our filter Units take a look at our Machine Coolant Filtration section or take a look at our article on how ofter to change filters.

 

 filter_change_proc-1.jpg

If you close the valve before you turn motor off you will not have to re-prime

filter_change_proc-2.jpg 

Turn the drain at the bottom and water will run out

filter_change_proc-3.jpg 

Break the filter seal with the wrench

filter_change_proc-13.jpg

Unscrew the filter housings by hand. Be careful The cartridge side is full of coolant

 filter_change_proc-4.jpg

Bag Support basket. Do not throw away Replace if bent

filter_change_proc-5.jpg

Do not change filters too soon. When full cartridges have a crust about 1/2” thick. Bags weigh app. 3# and have a 3/4” crust.

 filter_change_proc-6.jpg

Make sure the new bag is pushed all the way down in the bag

 filter_change_proc-7.jpg

Cartridge on the left and bag on the right

 filter_change_proc-8.jpg

Make sure “O” rings are not pinched. A little lubricant such as Vaseline will help seat the rings

 filter_change_proc-17.jpg

Seat the “O” rings completely

 filter_change_proc-9.jpg

Screw the canisters on by hand

 filter_change_proc-131.jpg

Tighten the canisters until you feel the “O” rings compress.

 

Change filters monthly. You can go longer but the waste packs tight and makes the filters really hard to change. Use genuine Carbide Processors filters. The right filter is critical. It is the difference between a month of good filtering or a couple hours of bad filtering.  Call us toll free at 1-800-346-8274 to purchase filters or Coolant Filtration Units.


b2b lead generation